2-5
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-03
Chapter 2 Configuring the Cable Modem Termination System for the First Time
Configuration Fundamentals for the Cisco uBR7200 Series
Booting and Logging onto the Cisco uBR7200 Series
The Cisco uBR7200 series router is administered using the Cisco command interpreter, called the EXEC.
You must boot and log in to the router before you can enter an EXEC command.
SUMMARY STEPS
1. Connect a terminal to the I/O controller console port of the Cisco uBR7200 series router and
establish a terminal session.
2. Power on the Cisco uBR7200 series router. Enter no to choose the normal operating mode of the
router.
3. Continue to password definition or recovery and additional configuration.
DETAILED STEPS
Setting Password Protection on the Cisco uBR7200 Series
Note For security purposes, the EXEC has two levels of access to commands: user EXEC mode and privileged
EXEC mode. The commands available at the user level are a subset of those available at the privileged level.
Tip Because many privileged-level EXEC commands are used to set operating parameters, password-protect
these commands to prevent unauthorized use.
Command or Action Purpose
Step 1
Connect a terminal to the I/O controller console port of the
Cisco uBR7200 series router and establish a terminal
session.
You can open a Terminal application (Hyper Terminal)
on a PC as follows:
a. Connect using: Direct to Com 1
b. Set bits per second: 9600
c. Set data bits: 8
d. Set parity: none
e. Set stop bit: 1
f. Set flow control: hardware
Step 2
Power on the Cisco uBR7200 series router. Enter no to
choose the normal operating mode of the router.
Example:
Would you like to enter the initial dialog?[yes]:
no
Router>
The user EXEC prompt appears.
Step 3
Continue to password definition or recovery and additional
configuration.
Refer to the remaining procedures in this chapter.
To Next Page
Loading...
Need help?
General
