1-22
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-05
Chapter 1 Overview of Cisco uBR7200 Series Software
Supported Software Features for the Cisco uBR7200 Series
Supported Software Features for the Cisco uBR7200 Series
This section summarizes Cisco uBR7200 series router software features for all supported Cisco IOS
Release trains, and directs you to additional configuration information for each feature.
Cisco uBR7200 Series Router Features and Cisco IOS Releases
Table 1-9 summarizes the software-related features and related Cisco IOS releases that support the
Cisco uBR7200 series router. Cisco IOS features indicate the first release in which the feature was
introduced. Unless otherwise noted, feature support continues in later releases of the same or related
Cisco IOS release train
Many additional features were introduced in release trains prior to those listed above, such as 12.0 T,
12.0
SC, 12.1 XF and other earlier releases that may no longer be supported on the Cisco uBR7200
Series. Refer to the release notes for your respective Cisco IOS release for additional feature support and
image information.
Ta b l e 1-9 Cisco uBR7200 Series Routers Features by Cisco IOS Release
Feature Supporting Cisco IOS Releases
Cisco uBR7200 Series Router Configuration Tools
Autoinstall 12.0 T, 12.0 XR, 12.0 SC, 12.1 EC, 12.1 CX, 12.2 BC and 12.3
BC releases
Cable Interface Setup Facility 12.1 EC, 12.1 CX, 12.2 BC and 12.3 BC releases
Cable Interface Extended Setup
Facility
12.1(3a)EC1 and all later Cisco IOS releases supporting the
Cisco uBR7200 Series CMTS
Cisco Network Registrar 12.1 EC, 12.2 BC, 12.3 BC
Interface Range Specification 12.0 T, 12.0 XR, 12.0 SC, 12.1 EC, 12.1 CX, 12.2 BC and 12.3
BC releases
Internal Modem Configuration File
Editor
12.2(1)XF1 and later 12.2 XF, 12.2 BC and 12.3 BC releases
Manual Configuration Mode for the
Cisco uBR7200 Series CMTS
All Cisco IOS releases supporting the Cisco uBR7200 Series
CMTS
Virtual Interface Support and
Frequency Stacking Support
12.3(9a)BC and later 12.3 BC releases
Bandwidth Management Features
Load Balancing Support 12.3(9a)BC and later 12.3 BC releases
Cisco IOS Command-Line Enhancements
exec prompt timestamp Command 12.1(12c)EC, 12.2(8)BC2 and later 12.1 EC, 12.2 BC and 12.3
BC releases
show Command Enhancements Multiple Cisco IOS software releases. Enhancements include:
• show cable qos
• show int cx/y sid
• show cable modem
• show cable modulation-profile
• show cable modem summary
To Next Page
Loading...
Need help?
General
