A-4
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-03
Appendix A Installing or Upgrading Cisco IOS Software
Copying a System Image from One Device to Another
Copying a System Image from One Device to Another
Copying from Device to Device Inside the Same Router
The table below provides command options for copying a system image from one device to another.
Methods vary according to different platforms.
The three most common commands used for image copying are:
copy tftp flash
copy rcp flash
copy slot0: slot1:
Refer to the Cisco IOS Configuration Fundamentals Command Reference, Release 12.1 on Cisco.com.
Detailed Example
Router# show slot0
-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
1 .D unknown 5E8B84E6 209D8 11 2392 Jan 22 2000 00:22:42 flashconfig
2 .. image 5E7BAE19 B623C4 22 11802988 Jan 22 2000 00:23:18 rsp-jsv-mz.1 20-8.0.2.T
Router# show slot1:
-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
1 .. unknown 6A2B4BA7 6FA9E0 20 7186784 Jul 30 1999 15:05:19 rsp-jv-mz.11 1-26.CC1
2 .. config 631F0D8B 6FB1EC 6 1929 Oct 19 1999 06:15:49 config
3 .. config 631F0D8B 6FB9F8 7 1929 Oct 19 1999 06:16:03 config1
Router# copy slot0: slot1
Source filename []? rsp-jsv-mz.120-8.0.2.T
Destination filename [slot1]?
CCCCCCCCCCCCCCCCCCCC
2392 bytes copied in 0.300 secs
Copying from One Router to Another
Perform these steps in global configuration mode.
Step 1 Display the system Flash directory with the show flash command:
Router# show flash
System flash directory:
File Length Name/status
1 11173264 c2500-jos56i-l.120-9.bin
[11173328 bytes used, 5603888 available, 16777216 total]
16384K bytes of processor board System flash (Read ONLY)
Step 2 Activate the TFTP server on the router that has the Cisco IOS software image that you want to copy. The
example below provides the command sequence to use:
Router# configure terminal
To Next Page
Loading...
Need help?
General
