Cisco 7912G User Manual

3-5
Cisco IP Phone 7905G/7912G User Guide for Cisco CallManager
78-15080-02
Chapter 3 Placing a Call and Other Basic Phone Tasks
Storing and Retrieving a Call Using Call Park
Step 3 When the call rings on the other end, press Trnsfer again. Or, when the party
answers, announce the call and then press Trnsfer.
If the party refuses the call, press the Hold button to return to the original call.
Redialing the Last Number Dialed
To redial the most recently dialed number, press the Redial softkey. Doing so
without lifting the handset activates the speaker.
Storing and Retrieving a Call Using Call Park
Call Park allows you to retrieve an incoming call from another phone, such as a
phone in another office or in a conference room. Call park numbers are
pre-configured for this purpose by your system administrator.
Procedure
Step 1 During an active call, press the more softkey until you see the Park tab.
Step 2 Press the Park softkey. The LCD screen displays the special call park number at
which the call is stored. If the screen does not display a call park number, the call
park feature is not available to you.
Step 3 Make a note of the call park number, then hang up. The call is parked at that
number, allowing you to retrieve it from another phone.
Step 4 To retrieve the parked call from any phone in the Cisco CallManager system, dial
the call park number at which the call is parked.
Note You have a limited amount of time to retrieve the parked call before it
reverts to ringing at its original destination. See your system
administrator for this time limit.

Cisco 7912G Specifications

General

Brand	Cisco
Model	7912G
Category	IP Phone
Language	English