Cisco 7912G - Removing the Last Caller on a Conference Call; Using Meet-Me Conferences; Establishing a Meet-Me Conference

3-13
Cisco IP Phone 7905G/7912G User Guide for Cisco CallManager
78-15080-02
Chapter 3 Placing a Call and Other Basic Phone Tasks
Making Conference Calls
Removing the Last Caller on a Conference Call
If you are the initiator of a conference call, you can disconnect the most recently
connected active party on the call by pressing the RmLstC softkey.
Using Meet-Me Conferences
Your Cisco IP Phone supports Meet-Me conferences. A Meet-Me conference
allows other callers to dial-in to the conference call. A Meet-Me conference
requires a special conference number which is pre-configured for this purpose by
your system administrator.
This section covers these topics:
• Establishing a Meet-Me Conference, page 3-13
• Joining a Meet-Me Conference, page 3-14
Establishing a Meet-Me Conference
To establish a Meet-Me conference call, perform the following steps.
Before You Begin
Contact your system administrator for the necessary Meet-Me conference number
or numbers.
Procedure
Step 1 Press the more softkey until you see the MeetMe tab.
Step 2 Press the MeetMe softkey.
Step 3 Dial the Meet-Me conference number.