Cisco 7961G User Manual

Then...If you want to...
Press .
Toggle speakerphone mode on or off
Lift the handset.Switch to a handset
Press during a call or after invoking a dial tone.
Press Save to preserve the volume level for future calls.
Adjust the volume level for a call
AutoAnswer with Headset or Speakerphone
When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings. Your
system administrator configures AutoAnswer to use either the speakerphone or a headset. You may use
AutoAnswer if you receive a high volume of incoming calls.
When AutoAnswer is enabled, you may hear a short ring. If this is distracting, lower the ringer volume.
Then...If you...
Keep headset mode active (in other words, keep illuminated), even when you are
not on a call.
To keep headset mode active, perform the following actions:
•
Press EndCall to hang up.
•
Press New Call or Dial to place new calls.
If your phone is set up to use AutoAnswer in headset mode, calls are automatically
answered only if is illuminated.
Otherwise, calls ring normally and you must manually answer them.
Use AutoAnswer
with a headset
Keep the handset in the cradle and headset mode inactive ( unlit).
Otherwise, calls ring normally and you must manually answer them.
Use AutoAnswer
with the
speakerphone
Tip
AutoAnswer is disabled when the Do Not Disturb feature is active.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
64
Handset, Headset, and Speakerphone
AutoAnswer with Headset or Speakerphone

Cisco 7961G Specifications

General

Brand	Cisco
Model	7961G
Category	IP Phone
Language	English