Cisco 8700 Series - Page 85

Figure 60: Optical Transceiver Extraction Tool ()
To use the Optical Transceiver Extraction Tool to remove an SFP28 or SFP+ module, follow these steps:
Procedure
Step 1 Remove the optical cable from the transceiver:
a) Hold the tool with the small hook at the top, as shown in the illustration.
Small hook:
• Squeeze the cable connector
1
Large hook:
• Grasp the optical cable
2
Front hook
• Grab the open bale clasp
• Remove the transceiver from the port
3
b) Place the opening of the extraction tool over the optical cable connector.
Note
The large hook should be in contact with the transceiver so that the small hook can squeeze the cable
connector.
Hardware Installation Guide for Cisco 8700 Series Routers
79
Connect Router to the Network
Using the Optical Transceiver Extraction Tool