DescriptionField
Defines when the phone reports its configuration to the provisioning servers.
• On Request: The phone reports its configuration only when an administrator sends
a sip notify event, or the phone restarts.
• On Local Change: The phone reports its configuration when any configuration
parameter changes by an action on the phone or on the phone administration web
page. The phone waits for a few seconds after a change is made, and then reports the
configuration. This delay ensures that changes are reported to the web server in batches,
rather than reporting a single change at a time.
• Periodically: The phone reports its configuration at regular intervals. The interval is
expressed in seconds.
Example XML configuration:
<Report_to_Server ua="na">
Periodically
</Report_to_Server>
Report to
Server:
Defines the interval (in seconds) that the phone reports its configuration to the provisioning
servers.
This field is used only when Report to Server is set to Periodically.
Default: 3600
Minimum: 600
Maximum: 2592000 (30 days)
Example XML configuration:
<Report_to_Server ua="na">
Periodically
</Report_to_Server>
<!available options: On Request | On Local Change| Periodically-->
<periodic_upload_to_server ua="na">
3600
</periodic_upload_to_server><User_Configurable_Resync ua="na">
Yes
</User_Configurable_Resync_
Periodic
Upload to
Server:
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
290
Cisco IP Phone Troubleshooting
Upload Configuration Options
To Next Page
Loading...
Need help?
General
