Name: Cisco 8865
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Make sure that the screws are fully inserted into the phone and tightened.

Note

Step 11 (Optional) Install the footstands on the phone and on the key expansion module, and adjust both footstands

to rest evenly on the work surface.

Step 12 Plug the Ethernet cable into the phone.

Connect Two or Three Key Expansion Modules to a Cisco IP

Phone

Procedure

Step 1 Unplug the Ethernet cable from the phone.

Step 2 If installed, remove the footstand from the phone.

Step 3 Locate the accessory connector covers on the side of the phone.

This diagram shows the location.

Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide

114

Hardware and Accessory Installation

Connect Two or Three Key Expansion Modules to a Cisco IP Phone

Other manuals for Cisco 8865

Questions and Answers:

Need help?

Do you have a question about the Cisco 8865 and is the answer not in the manual?

General