CHAPTER 5
Configuring the Satellite nV Optical Shelf System
This chapter describes the configuration of the Satellite Network Virtualization (Satellite nV) Optical Shelf
system on the Cisco ASR 9000 Series Aggregation Services Routers.
•
Prerequisites of nV Optical System, page 113
•
Overview of the Satellite nV Optical Shelf System, page 114
•
Configuring the Satellite Optical Shelf Identity and Connection Parameters, page 115
•
Provisioning an Optical Application, page 117
•
Configuring a Client Port, page 121
•
Provisioning a Chassis for Optical Shelf, page 122
Prerequisites of nV Optical System
The following are the requirements and prerequisites for nV optical shelf system configuration:
•
Ensure the version of software on the satellite is VxWorks 10.00.01 (10.01).
•
Factory reset the satellite system.
•
Ensure the DWDM software package is installed on the satellite. For example, the packages to be installed
on Cisco ONS15454 and on Cisco NCS 2000 Series are ons15454.DWDM.K9.R10011.pkg and
NCS2K.L.K9.R10011.pkg respectively.
•
Configure the satellite directly using Cisco Transport Controller (CTC) interface with the connection
settings, such as IP address, username, and password.
For more information about the settings, see the Implementing a Satellite nV System, on page 35
chapter. For information about CTC, see the Cisco Transport Controller chapter in Cisco ONS 15454
Reference Manual.
•
For the optical shelf system to collect data for performance monitoring, configure Network Time Protocol
(NTP) and set the satellite's clock to UTC timezone.
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
113
To Next Page
Loading...
Need help?
General
