CHAPTER 6
Configuring the Performance Monitoring
Thresholds for the Satellite nV Optical System
This chapter describes how to configure the thresholds for Performance Monitoring (PM) parameters of a
controller and display them.
•
Displaying the Performance Monitoring Parameters of a Controller, page 125
•
Configuring the Thresholds for Optics Performance Monitoring Parameters, page 127
•
Configuring the Thresholds for ODU Performance Monitoring Parameters, page 127
•
Configuring the Thresholds for OTU Performance Monitoring Parameters, page 129
•
Configuring the Thresholds for Ethernet Performance Monitoring Parameters, page 130
Displaying the Performance Monitoring Parameters of a
Controller
Depending on the type of a controller, perform any of the following tasks to view the Performance Monitoring
(PM) parameters of the controller. Before viewing the PM parameters, a controller should be created.
Optics Controller
The following command displays the current performance parameters of an Optics controller for 15-minutes
and 24-hour intervals:
show controllers optics R/S/I/P pm current [ 15-min | 24-hour ] optics layer
layer is a number between 1 and 12 depending on the specific hardware whose PM data needs to be displayed.
Here are a few examples:
router# show controllers optics 100/3/0/2 pm current 15-min optics 12
The following commands display the historical performance parameters of an Optics controller for 15-minutes
and 24-hour intervals:
show controllers optics R/S/I/P pm history 15-min optics layer bucket bucket-number
bucket-number is a number between 1 and 32.
show controllers optics R/S/I/P pm history 24-hour optics layer
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
125
To Next Page
Loading...
Need help?
General
