Cisco A9K-SIP-700 System Configuration Guide

Satellite Management Using Private VRF
You can use a special private VRF instead of the global default routing table, to configure the loopback
interface and ICLs used for satellite management traffic. IP addresses in this VRF will not conflict with any
other addresses used on the router.
router(config)# vrf NV_MGMT_VRF
router(config)# address ipv4 unicast
router(config)# interface Loopback 1000
router(config)# vrf NV_MGMT_VRF
router(config)# ipv4 address 10.0.0.1 / 24
router(config)# interface TenGige 0/1/0/3
router(config)# vrf NV_MGMT_VRF
router(config)# ipv4 point-to-point
router(config)# ipv4 unnumbered Loopback 1000
router(config)# nv
router(config-nv)# satellite-fabric-link satellite 500
router(config-nv)# remote-ports GigabitEthernet 0/0/28-39
router(config)# nv satellite 500
router(config)# ipv4 address 10.0.0.2 / 24
Configuration of Satellite using Auto-IP
show run nv satellite 1200
nv
satellite 1200
type asr901
!
interface GigabitEthernet0/1/0/5
transceiver permit pid all
nv
satellite-fabric-link satellite 1200
remote-ports GigabitEthernet 0/0/0-7
!
!
!
Satellite Configuration with Dual-Homed Hosts
You can configure satellite with dual-homed hosts as shown in this example.
redundancy
iccp
group <group-id>
member
neighbor <ip-address>
!
backbone
interface <interface-id>
!
isolation recovery-delay <value>
nv satellite
system-mac <macaddr>
!
!
!
interface TenGigE0/1/0/0
nv
satellite-fabric-link {network | satellite <id>}
redundancy
iccp-group <group-id>
!
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
67
Configuring the Satellite Network Virtualization (nV) System
Configuration of Satellite using Auto-IP

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English