PurposeCommand or Action
Ends the policy map configuration.end-policy-map
Example:
RP/0/RSP0/CPU0:router(config-pmap)#
end-policy-map
Step 9
Configures an interface and enters the interface configuration
mode.
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
gigabitethernet 100/0/0/0
Step 10
(Optional)
Configures the L2 transport offload for satellite.
l2transport
Example:
RP/0/RSP0/CPU0:router(config-if)# l2transport
Step 11
Enters the satellite network virtualization (nV) configuration
submode.
nv
Example:
RP/0/RSP0/CPU0:router(config-if)# nv
Step 12
Attaches a policy map to an input interface to be used as the
service policy for that interface.
service-policy input policy-map
Example:
RP/0/RSP0/CPU0:router(config-if-nV)#
service-policy input policy1
Step 13
commit
Step 14
Offloading Service-policy on Bundle Access Port
Perform these tasks to offload the service-policy on the bundle access port. This procedure offloads the
service-policy in the ingress direction of the Satellite Ethernet interface.
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
80
Configuring QoS on the Satellite System
Offloading Service-policy on Bundle Access Port
To Next Page
Loading...
Need help?
General
