Configuring the ASR 9000v as a satellite in Host B:
nv
satellite 100
type asr9000v
ipv4 address 100.0.0.3
description sat100
serial-number CAT1708U0NA
!
!
Configuring the fabric interface for the satellite on Host A:
interface Loopback100
ipv4 address 100.0.0.1 255.255.255.0
!
interface Bundle-Ether100
ipv4 point-to-point
ipv4 unnumbered Loopback100
nv
satellite-fabric-link satellite 100
redundancy
iccp-group 1
!
remote-ports GigabitEthernet 0/0/0-43
!
!
!
interface TenGigE0/0/0/0
bundle id 100 mode on
!
Configuring the fabric interface for the satellite on Host B:
interface Loopback100
ipv4 address 100.0.0.2 255.255.255.0
!
interface TenGigE0/0/0/0
ipv4 point-to-point
ipv4 unnumbered Loopback100
nv
satellite-fabric-link satellite 100
redundancy
iccp-group 1
!
remote-ports GigabitEthernet 0/0/0-43
!
!
!
Configuring ICCP Redundancy and MPLS LDP on Host A:
redundancy
iccp
group 1
member
neighbor 70.0.0.2
!
!
!
!
mpls ldp
router-id 70.0.0.1
address-family ipv4
discovery targeted-hello accept
!
interface TenGigE0/0/0/1
!
!
Configuring ICCP Redundancy and MPLS LDP on Host B:
redundancy
iccp
group 1
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
50
Configuring the Satellite Network Virtualization (nV) System
Configuration Examples of SyncE on ASR9000 Hosts
To Next Page
Loading...
Need help?
General
