CHAPTER 7
Managing the Router Hardware
This chapter describes the command-line interface (CLI) techniques and commands used to manage and
configure the hardware components of a router running the Cisco IOS XR software.
For complete descriptions of the commands listed in this module, see Additional References, on page 127.
To locate documentation for other commands that might appear in the course of performing a configuration
task, search online in Cisco ASR 9000 Series Aggregation Services Router Commands Master List.
Table 14: Feature History for Managing Router Hardware with Cisco IOS XR Software
ModificationRelease
This feature was introduced.Release 3.7.2
This module contains the following topics:
•
Prerequisites for Managing Router Hardware, page 100
•
Displaying Hardware Status, page 100
•
RSP Redundancy and Switchover, page 115
•
Reloading, Shutting Down, or Power Cycling a Node, page 119
•
Flash Disk Recovery, page 122
•
Using Controller Commands to Manage Hardware Components, page 123
•
Formatting Hard Drives, Flash Drives, and Other Storage Devices, page 123
•
Removing and Replacing Cards, page 124
•
Upgrading the CPU Controller Bits, page 126
•
Additional References, page 127
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
99
To Next Page
Loading...
Need help?
General
