•
Verify that the ROMMON version is correct. For instructions on upgrading ROM Monitor, see
Cisco ASR 9000 Series Aggregation Services Router ROM Monitor Guide.
•
All packages to be upgraded or added are present on a local storage device (for example a flash disk),
or a network file server.
•
Prerequisites for the activation of packages are met as described in the Prerequisites section.
•
Complete the procedures described in the Preparing for Software Installation Operations, on page 38
section.
To use the automatic FPD upgrade feature, the fpd auto-upgrade command must be enabled in
administration configuration mode.
Note
SUMMARY STEPS
1.
Connect to the console port and log in.
2.
(Optional) dir flash-disk :
3.
admin
4.
install add [source source-path | tar] file [activate ]
5.
(Optional) show install inactive summary
6.
install activate {id add-id | device package} [test] [location node-id] [pause sw-change] [prompt-level
{all | none}] [auto-abort-timer {time | off}]
7.
Repeat Step 4, on page 50 through Step 6, on page 51 until all packages are activated.
8.
(Optional) show install active summary
9.
(Optional) install verify packages
10.
(Optional) exit
11.
(Optional) show system verify start
12.
admin
13.
(Optional) install commit
14.
Upgrade the field-programmable device (FPD) software, if necessary.
DETAILED STEPS
PurposeCommand or Action
Establishes a CLI management session with the SDR. Connect
to the console port for the active DSC.
Connect to the console port and log in.
Step 1
For more information on console connections, see
Cisco ASR 9000 Series Aggregation Services Router Getting
Started Guide.
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
49
Upgrading and Managing Cisco IOS XR Software
Adding and Activating Packages
To Next Page
Loading...
Need help?
General
