C-3
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
Appendix C Access Point/Bridge Specifications
Data rates IEEE 802.11g-compliant radio:
100, 50, 30, 20, 5, or 1 mW (at 1, 2, 5.5 and
11 Mbps)
30, 20, 10, 5, or 1 mW (at 6, 9, 12, 18, 24, 48,
and 54 Mbps)
(Depending on the regulatory domain in which the
access point/bridge is installed)
—
Non-overlapping
channels
3—
Antenna Integrated antenna
13-dBi patch array
Some external antennas:
5.2-dBi omnidirectional
12-dBi omnidirectional
9-dBi patch
10-dBi yagi
13.5-dBi yagi
14-dBi sector
21-dBi dish
(Depending on the regulatory region)
—
Environmental Air
Space
The access point/bridge and power injector provide adequate fire resistance and low smoke-producing
characteristics suitable for operation in a building's environmental air space, such as above suspended
ceilings, in accordance with Section 300-22(C) of the National Electrical Code (NEC) and Sections
2-128, 12-010(3) and 12-100 of the Canadian Electrical Code, Part 1, C22.1.
Caution The power module is not tested to UL 2043 and should not be placed in a building’s
air-handling spaces, such as above suspended ceilings.
Safety access point/bridge:
UL 60950
UL 2043
CSA C22.2 No. 60950
IEC 60950
EN 60950
Power injector:
UL 2043
Power injector and power module:
UL 60950
CSA C22.2 No. 60950
IEC 60950
EN 60950
Note The power injector and power module
must be used in an indoor
environment.
Table C-1 Access Point/Bridge, Power Injector, and Power Module Specifications (continued)
Category Access Point/Bridge Power Injector and Power Module
To Next Page
Loading...
