CHAPTER
5-1
Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-02
5
Configuring the Access Point/Bridge for the First
Time
This chapter describes how to configure basic settings on your access point/bridge for the first time using
the web-browser interface. You can configure all the settings described in this chapter using the
command-line interface (CLI), but it might be simplest to browse to the access point/bridge’s
web-browser interface to complete the initial configuration and then use the CLI to enter additional
settings for a more detailed configuration.
This chapter contains these sections:
• Before You Start, page 5-2
• Resetting the Access Point/Bridge to Default Settings, page 5-2
• Default IP Address Behavior, page 5-2
• Default SSID and Default Role, page 5-3
• Obtaining and Assigning an IP Address, page 5-3
• Connecting to the Access Point/Bridge Locally, page 5-4
• Assigning Basic Settings, page 5-5
• Adjusting Output Power Level, page 5-9
• Configuring Basic Security Settings, page 5-9
• Finding the IP Address Using the CLI, page 5-13
• Assigning an IP Address Using the CLI, page 5-14
• Using a Telnet Session to Access the CLI, page 5-14
To Next Page
Loading...
