Cisco ATA 186 Administrator's Guide

5-35
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (H.323)
OL-4008-01
Chapter 5 Parameters and Defaults
Optional Feature Parameters
• Bits 18-29—User-specified 802.1Q VLAN ID.
• Bits 30-31—Reserved.
Value Type
Bitmap
Default
0x0000002b
Voice Configuration Menu Access Code
324
Related Parameter
OpFlags, page 5-33
Optional Feature Parameters
This section includes the parameters used to configure various timeout values and call-progress tones:
• NPrintf, page 5-35
• RingOnOffTime, page 5-36
• IPDialPlan, page 5-36
• DialPlan, page 5-37
• Call-Progress Tone Parameters, page 5-41
• CallCmd, page 5-46
NPrintf
Description
Use this parameter to specify the IP address and port of a host to which all Cisco ATA debug messages
are sent. The program prserv.exe, which comes bundled with the Cisco ATA software, is needed to
capture the debug information.
Syntax
<HOST_IP>,<HOST_PORT>
Example
If the program prserv.exe is running on a host with IP address 192.168.2.170 and listening port 9001, set
NPrintf to 192.168.2.170.9001. This causes the Cisco ATA to send all debug traces to that IP address.
Value Type
Extended IP address
Default
0

Cisco ATA 186 Specifications

General

Operating Temperature	32°F to 104°F (0°C to 40°C)
Protocol	SIP, H.323
Network Interface	10/100BASE-T Ethernet
Audio Codec Support	G.729a, G.723.1
Power Supply	5V DC
Weight	0.23 kg (0.5 lb)
Relative Humidity	10 to 90% noncondensing
Ports	2 RJ-11 FXS ports