Cisco ATA 186 Administrator's Guide

5-21
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (H.323)
OL-4008-01
Chapter 5 Parameters and Defaults
Operating Parameters
RxCodec
Description
Use this parameter to specify receiving-audio codec preference. The following values are valid:
• 0—G.723 (can be selected only if LBRCodec is set to 0)
• 1—G.711A-law
• 2—G.711µ-law
• 3—G.729A (can be selected only if LBRCodec is set to 3)
Value Type
Integer
Range
0-3
Default
2
Table 5-1 AudioMode Parameter Bit Definitions
Bit Number Definition
0 and 16 0/1—Disable/enable silence suppression for all audio codecs. Silence suppression is enabled by
default.
1 and 17 0—Enable selected low-bit-rate codec in addition to G.711. This setting is the default.
1—Enable G.711 only.
2 and 18 0/1—Disable/enable fax CED tone detection. This feature is enabled by default.
3 and 19 Reserved.
4-5 and 20-21 DTMF Transmission Method:
• 0—Always in-band.
• 1—By negotiation.
• 2—Always out-of-band.
• 3—Reserved.
6-7 and 22-23 Hookflash Transmission Method:
• 0—Disable sending OOB hookflash message.
• 1—By negotiation (H.245 message).
• 2—Always out-of-band (H.245 message).
• 3—Use Q931message to send user keypad information for DTMF or hookflash transmission.
8-15 and 23-31 Reserved.

Cisco ATA 186 Specifications

General

Operating Temperature	32°F to 104°F (0°C to 40°C)
Protocol	SIP, H.323
Network Interface	10/100BASE-T Ethernet
Audio Codec Support	G.729a, G.723.1
Power Supply	5V DC
Weight	0.23 kg (0.5 lb)
Relative Humidity	10 to 90% noncondensing
Ports	2 RJ-11 FXS ports