EasyManuals Logo

Cisco Catalyst 250 Series Hardware Installation Guide

Cisco Catalyst 250 Series
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
CAB-STK-E-0.5M= (0.5-meter cable)
CAB-STK-E-1M= (1-meter cable)
CAB-STK-E-3M= (3-meter cable)
Make sure that you have access to the switch rear panel and to the rear of the rack.
Installing the FlexStack-Plus Module
The switch should always have a blank module installed when a FlexStack-Plus module is not used.Note
The Catalyst 2960X-48P-L switch is shown as an example. You can install the module in other switches as
shown.
Procedure
Step 1
Use a number 2 Phillips-head screwdriver to remove the FlexStack-Plus module blank cover on the switch
back panel.
Step 2
Grasp the FlexStack-Plus module on the sides, and insert it into the module slot. Push the module in completely
until you feel it snap into place.
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
OL-28309-02 29
Switch Installation
Installing the FlexStack-Plus Module

Table of Contents

Other manuals for Cisco Catalyst 250 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 250 Series and is the answer not in the manual?

Cisco Catalyst 250 Series Specifications

General IconGeneral
BrandCisco
ModelCatalyst 250 Series
CategorySwitch
LanguageEnglish

Related product manuals