Cisco Catalyst 250 Series User Manual

Related Topics
Configuring VLAN Maps, on page 172
Creating Named Standard ACLs
Follow these steps to create a standard ACL using names:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip access-list standard name
4.
Use one of the following:
•
deny {source [source-wildcard] | host source | any} [log]
•
permit {source [source-wildcard] | host source | any} [log]
5.
end
6.
show running-config
7.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Defines a standard IPv4 access list using a name, and enter
access-list configuration mode.
ip access-list standard name
Example:
Switch(config)# ip access-list standard 20
Step 3
The name can be a number from 1 to 99.
In access-list configuration mode, specify one or more
conditions denied or permitted to decide if the packet is
forwarded or dropped.
Use one of the following:
Step 4
•
deny {source [source-wildcard] | host source | any}
[log]
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
160 OL-29048-01
Configuring IPv4 ACLs
Creating Named Standard ACLs

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English