EasyManuals Logo

Cisco Catalyst 250 Series User Manual

Cisco Catalyst 250 Series
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #376 background imageLoading...
Page #376 background image
Related Topics
Flexible Authentication Ordering, on page 291
Configuring Open1x
Beginning in privileged EXEC mode, follow these steps to enable manual control of the port authorization
state:
SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
switchport mode access
4.
authentication control-direction {both | in}
5.
authentication fallback name
6.
authentication host-mode [multi-auth | multi-domain | multi-host | single-host]
7.
authentication open
8.
authentication order [ dot1x | mab ] | {webauth}
9.
authentication periodic
10.
authentication port-control {auto | force-authorized | force-un authorized}
11.
end
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specifies the port to be configured, and enter interface
configuration mode.
interface interface-id
Example:
Switch(config)# interface gigabitethernet 1/0/1
Step 2
Sets the port to access mode only if you configured
the RADIUS server.
switchport mode access
Example:
Switch(config-if)# switchport mode access
Step 3
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
352 OL-29048-01
Configuring IEEE 802.1x Port-Based Authentication
Configuring Open1x

Table of Contents

Other manuals for Cisco Catalyst 250 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 250 Series and is the answer not in the manual?

Cisco Catalyst 250 Series Specifications

General IconGeneral
BrandCisco
ModelCatalyst 250 Series
CategorySwitch
LanguageEnglish

Related product manuals