Cisco Catalyst 250 Series User Manual

•
You enable voice aware 802.1x security by entering the errdisable detect cause security-violation
shutdown vlan global configuration command. You disable voice aware 802.1x security by entering
the no version of this command. This command applies to all 802.1x-configured ports in the switch.
If you do not include the shutdown vlan keywords, the entire port is shut down when
it enters the error-disabled state.
Note
•
If you use the errdisable recovery cause security-violation global configuration command to configure
error-disabled recovery, the port is automatically re-enabled. If error-disabled recovery is not configured
for the port, you re-enable it by using the shutdown and no shutdown interface configuration commands.
•
You can re-enable individual VLANs by using the clear errdisable interface interface-id vlan [vlan-list]
privileged EXEC command. If you do not specify a range, all VLANs on the port are enabled.
Beginning in privileged EXEC mode, follow these steps to enable voice aware 802.1x security:
SUMMARY STEPS
1.
configure terminal
2.
errdisable detect cause security-violation shutdown vlan
3.
errdisable recovery cause security-violation
4.
clear errdisable interfaceinterface-id vlan [vlan-list]
5.
Enter the following:
•
shutdown
•
no shutdown
6.
end
7.
show errdisable detect
DETAILED STEPS
PurposeCommand or Action
Enter global configuration mode.configure terminal
Step 1
Shut down any VLAN on which a security violation error occurs.errdisable detect cause security-violation
shutdown vlan
Step 2
If the shutdown vlan keywords are not included, the entire
port enters the error-disabled state and shuts down.
Note
Enter global configuration mode.errdisable recovery cause
security-violation
Step 3
(Optional) Reenable individual VLANs that have been error disabled.
clear errdisable interfaceinterface-id vlan
[vlan-list]
Step 4
•
For interface-id specify the port on which to reenable individual
VLANs.
•
(Optional) For vlan-list specify a list of VLANs to be re-enabled.
If vlan-list is not specified, all VLANs are re-enabled.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 303
Configuring IEEE 802.1x Port-Based Authentication
Configuring Voice Aware 802.1x Security

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English