Cisco Catalyst 250 Series User Manual

PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Enables the small-frame rate-arrival feature on the switch.errdisable detect cause small-frame
Example:
Switch(config)# errdisable detect cause
Step 3
small-frame
(Optional) Specifies the time to recover from the specified
error-disabled state.
errdisable recovery interval interval
Example:
Switch(config)# errdisable recovery interval
Step 4
60
(Optional) Configures the recovery time for error-disabled
ports to be automatically re-enabled after they are error
disabled by the arrival of small frames
errdisable recovery cause small-frame
Example:
Switch(config)# errdisable recovery cause
Step 5
Storm control is supported on physical interfaces. You can
also configure storm control on an EtherChannel. When storm
small-frame
control is configured on an EtherChannel, the storm control
settings propagate to the EtherChannel physical interfaces.
Enters interface configuration mode, and specify the interface
to be configured.
interface interface-id
Example:
Switch(config)# interface
Step 6
gigabitethernet1/0/2
Configures the threshold rate for the interface to drop
incoming packets and error disable the port. The range is 1 to
10,000 packets per second (pps)
small-frame violation-rate pps
Example:
Switch(config-if)# small-frame violation rate
Step 7
10000
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 8
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
396 OL-29048-01
Configuring Port-Based Traffic Control
Configuring Small-Frame Arrival Rate

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English