Cisco Catalyst 2960-X Series User Manual

Power Supply Modules (Applies to the Catalyst 2960-XR Switches) 19
Management Options 20
Network Configurations 21
CHAPTER 2 Switch Installation 23
Safety Warnings 23
Box Contents 26
Tools and Equipment 26
Installation Guidelines 26
Verifying Switch Operation 27
Planning and Installing a Switch Stack (Optional) 28
Stack Guidelines 28
Installing the FlexStack-Plus Module 29
Stack Cabling 31
Stack Bandwidth and Partitioning Examples 32
Power-On Sequence for Switch Stacks 33
Installing the Switch 33
Rack-Mounting 33
Attaching the Rack-Mount Brackets for the Catalyst 2960-X Switches 35
Attaching the Rack-Mount Brackets for the Catalyst 2960-XR Switches 36
Mounting in a Rack 37
Wall-Mounting 38
Attaching the Brackets for Wall-Mounting 38
Attaching the RPS Connector Cover 39
Mounting on a Wall 40
Installing the Switch on a Table or Shelf 41
After Switch Installation 41
Connecting the FlexStack Cables (Optional) 41
Removing a FlexStack Cable 42
Installing the Power Cord Retainer (Optional) 43
Installing SFP and SFP+ Modules 45
Installing an SFP or SFP+ Module 46
Removing an SFP or SFP+ Module 47
Connecting to SFP and SFP+ Modules 47
Connecting to Fiber-Optic SFP and SFP+ Modules 48
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
iv OL-28309-02
Contents

Cisco Catalyst 2960-X Series Specifications

General

Operating System	Cisco IOS
Form Factor	Rack-mountable
RAM	512 MB
Model	2960-X Series
Ports	48 x Gigabit Ethernet
Uplink Interfaces	Optional 1G or 10G uplinks
Switching Capacity	Up to 160 Gbps
Stacking	Yes, up to 8 switches
Power over Ethernet	PoE+ (IEEE 802.3at) available on selected models
Dimensions	4.4 x 45 x 28.2 cm (1.73 x 17.7 x 11.1 in)
Weight	5.4 kg
VLANs	4096
Jumbo Frame Support	9198 bytes
Power Supply	100-240VAC, 50-60 Hz
Features	Layer 2 and Layer 3 features, QoS, IPv6 support
Software	LAN Base
Operating Temperature	0 to 45°C (32 to 113°F)