Preface
Organization
x
Catalyst 3550 Multilayer Switch Hardware Installation Guide
78-11358-01
Organization
This guide is organized into these chapters:
Chapter 1, “Product Overview,” is a physical and functional overview of the
switch. It describes the switch ports, the standards they support, and the switch
LEDs.
Chapter 2, “Installing and Starting the Switch,” contains the procedures for
installing a switch in a rack, on a table, or shelf. It also describes installing
Gigabit Interface Converter (GBIC) modules, how to power the switch, and how
to make port connections.
Chapter 3, “Troubleshooting,” describes how to identify and resolve some of the
problems that might arise when installing the switch.
Appendix A, “Technical Specifications,” lists the physical and environmental
specifications for the switch and the regulatory agency approvals.
Appendix B, “Connector and Cable Specifications,” describes the connectors,
cables, and adapters that can be used to connect to the switch.
Appendix C, “Translated Safety Warnings,” contains translations in various
languages of the warnings in this guide.
Conventions
This document uses these conventions and symbols for notes, cautions, and
warnings:
Note Means reader take note. Notes contain helpful suggestions or references to
materials not contained in this manual.
Caution Means reader be careful. In this situation, you might do something that could
result in equipment damage or loss of data.
To Next Page
Loading...
Need help?
General
