Cisco Catalyst 3550

2-23
Catalyst 3550 Multilayer Switch Hardware Installation Guide
78-11358-01
Chapter 2 Installing and Starting the Switch
Where to Go Next
Figure 2-14 Connecting to the Console Port
Step 3
Attach the supplied RJ-45-to-DB-9 female DTE adapter to a PC, or attach an
appropriate adapter to the terminal.
Step 4 Insert the other end of the supplied rollover cable in the attached adapter.
Step 5 Boot the terminal-emulation program if you are using a PC or terminal.
Where to Go Next
If the default configuration is satisfactory, the switch does not need further
configuration. You can use any of these management options to change the default
configuration:
• Start the Cluster Management Suite, as described in the Catalyst 3550
Multilayer Switch Software Configuration Guide, and configure the switch as
a member of a cluster or as an individual switch. Refer to the release notes on
Cisco.com for the most current browser requirements.
• Use the CLI to configure the switch from the console. Refer to the
Catalyst 3550 Multilayer Switch Software Configuration Guide and the
Catalyst 3550 Multilayer Switch Command Reference for information on
using the CLI with a Catalyst 3550 switch.
• Start an SNMP application such as the CiscoView application.
10
0-2
40
V
~
5
-3
A
5
0/60
H
z
CONSO
LE
Rollover
cable
RJ-45
console
port
50376