Cisco Catalyst 3650 Series Configuration Guide

DescriptionParameter
Timeout in seconds for disabled client machines that you can enable or disable. Client machines
are disabled by their MAC address and their status can be observed on the Clients > Details
page. A timeout setting of 0 indicates that the client is disabled permanently. Administrative
control is required to reenable the client. The default is enabled and the timeout setting is
configured as 60 seconds.
Client Exclusion
The minimum timeout value allowed is 0 seconds and the maximum timeout value allowed is
2147483647 seconds.
Timeout Value (secs)
Maximum clients allowed per Switch.
You can set a limit to the number of clients that can connect to a WLAN. This feature is useful
in scenarios where you have a limited number of clients that can connect to a Switch. You can
set a limit on the number of guest clients that can access a given WLAN. The number of clients
that you can configure per WLAN depends on the platform that you are using. A maximum of
up to 12000 clients are supported.
The maximum number of clients per WLAN feature is supported only for access points
that are in connected mode.
Note
Max Allowed Client
DHCP
Enter the DHCP server on the WLAN that overrides the DHCP server address on the interface
assigned to the WLAN.
DHCP Server IP
Address
Enables the DHCP address assignment and makes it mandatory for clients to get their IP address
from the DHCP server.
DHCP Address
Assignment Required
Enables the DHCP82 payload on the WLAN.DHCP Option 82
Specifies the DHCP option 82 format. Values are as follows:
• add-ssid— Set RemoteID format that is the AP radio MAC address and SSID.
• ap-ethmac—Set RemoteID format that is the AP Ethernet MAC address.
If the format option is not configured, only the AP radio MAC address is
used.
Note
DHCP option 82
Format
Configures ASCII for DHCP Option 82. If this is not configured, the option 82 format is set
to ASCII format.
DHCP Option ASCII
Mode
Adds the Cisco 2 Byte RID for DHCP option 82.DHCP Option 82 RID
Mode
NAC
Enables the NAC on the WLAN.NAC State
Off Channel Scanning Defer
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
OL-32353-01 41
Configuring WLANs
Configuring Advanced WLAN Properties (GUI)

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)