DescriptionParameter
Defer priority for the channel scan that you can assign by clicking on the priority argument.
The valid range for the priority is 0 to 7. The priority is 0 to 7 (this value should be set to 6 on
the client and on the WLAN).
Multiple values can be set. The default values are 4, 5 and 6.
Scan Differ Priority
Channel scan defer time in milliseconds that you can assign. The valid range is 100 (default)
to 60000 (60 seconds). This setting should match the requirements of the equipment on your
wireless LAN.
Scan Differ Time
Override Interface ACL
The WLANs IPv4 ACL group. Values are as follows:
•
Un-configured
•
Pre-auth_ipv4_acl
IPv4 ACL
The WLANs IPv6 ACL group. Values are as follows:
•
Un-configured
•
Pre-auth_ipv6_acl
IPv6 ACL
Step 6
Click Apply.
Related Topics
Band Selection, on page 24
Off-Channel Scanning Defer
DTIM Period
Session Timeout
Cisco Client Extensions, on page 25
Peer-to-Peer Blocking, on page 26
Diagnostic Channel
Client Count Per WLAN
Prerequisites for WLANs, on page 21
Restrictions for WLANs, on page 22
Information About the Dynamic Host Configuration Protocol, on page 48
Internal DHCP Servers, on page 49
External DHCP Servers, on page 49
DHCP Assignments, on page 50
Information About DHCP Option 82, on page 51
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
42 OL-32353-01
Configuring WLANs
Configuring Advanced WLAN Properties (GUI)
To Next Page
Loading...
Need help?
General
