Chapter 1 Module Overview and Specifications
Catalyst 4500 Series Switches
1-2
Catalyst 4500 Series Module Installation Guide
78-13267-06
Catalyst 4500 Series Switches
The Catalyst 4500 series switches consist of the Catalyst 4503 switch, the
Catalyst 4506 switch, the Catalyst 4507R switch, and the Catalyst 4510R switch.
The switches are designed for high-performance, high-density wiring closet
applications. A detailed overview of these switches is in the Catalyst 4500 Series
Installation Guide.
Supervisor Engines
These sections describe the supervisor engines available for the Catalyst 4500
series switches:
• Supervisor Engine I (WS-X4012), which is used in the Catalyst 4003 switch
(Figure 1-1)
• Supervisor Engine II (WS-X4013, which is used in the Catalyst 4006, 4503,
and 4506 switches (Figure 1-2)
• Supervisor Engine II-Plus (WS-X4013+), which is used in the Catalyst 4006,
4503, 4506, and 4507R switches (Figure 1-3)
• Supervisor Engine II-Plus TS (WS-X4013+TS), which is used in Catalyst
4503 switches only (Figure 1-4)
• Supervisor Engine II-Plus 10GE (WS-X4013+10GE), which is used in
Catalyst 4503, 4506, and 4507R switches (Figure 1-5)
• Supervisor Engine III (WS-X4014), which is used in the Catalyst 4006, 4503,
and 4506 switches (Figure 1-6)
• Supervisor Engine IV (WS-X4515), which is used in the Catalyst 4006, 4503,
4506, and 4507R switches (Figure 1-7 )
• Supervisor Engine V (WS-X4516), which is used in the Catalyst 4006, 4503,
4506, 4507R, and 4510R switches (Figure 1-8)
• Supervisor Engine V-10GE (WS-X4516-10GE), which is used in the
Catalyst 4503, 4506, 4507R, and 4510R switches (Figure 1-9)
On the Catalyst 4006, 4503, and 4506 switches, you can install the Supervisor
Engine in slot 1 only. On the Catalyst 4507R or 4510R switch, you install the
primary supervisor engine in slot 1, and you can install an optional redundant
supervisor engine in slot 2.
To Next Page
Loading...
Need help?
General
