Cisco Catalyst 4500 Series - WS-U4504-FX-MT Uplink Module

Chapter 1 Module Overview and Specifications
Ethernet and Fast Ethernet Switching Modules
1-28
Catalyst 4500 Series Module Installation Guide
78-13267-06
WS-U4504-FX-MT Uplink Module
The WS-U4504-FX-MT uplink module (see Figure 1-26) has the following
specifications:
Figure 1-26 WS-U4504-FX-MT Uplink Module
The WS-U4504-FX-MT uplink module is installed onto a switching module to
provide optional port configurations.
Each port has a port link status LED below it, which is labeled N+x. The N
indicates the last number of the port that is used on the Ethernet switching module
(WS-X4232-RJ-XX).
For the far left port on the WS-U4504-FX-MT uplink module, add 1 to that
number; for the second port, add 2; for the third port, add 3; for the last port, add 4.
Specification Description
Module type 100BASE-FX uplink module
Port duplex mode Half or full duplex mode
Port speed 100 Mbps
Number of ports 4
Connector type MT-RJ (See Figure 2-4 on page 2-4.)
Cable type MMF cable
N+1
23837
WS-U4504-FX-MT
N+2 N+3 N+4