Need help?Do you have a question about the Cisco Catalyst 4500e Series and is the answer not in the manual?
General| Series | Catalyst 4500E Series |
|---|---|
| Stackable | No |
| Chassis Options | 3-slot, 6-slot, 7-slot, 10-slot |
| Power Supply Options | AC, DC |
| Redundancy | Power supply redundancy, supervisor engine redundancy (1+1) |
| Layer Support | Layer 2 |
| Virtualization | Yes (Virtual Switching System - VSS) |
| Form Factor | Modular |
| Ports | Gigabit Ethernet, 10 Gigabit Ethernet, 40 Gigabit Ethernet, and 100 Gigabit Ethernet options depending on the line cards |
| Jumbo Frame Support | Yes |
| Features | Flexible NetFlow, TrustSec |
| Maximum Port Density | Up to 384 ports per chassis |
| Operating System | Cisco IOS XE |
| Management | CLI, SNMP, Cisco Prime Infrastructure, Cisco DNA Center |
| Security Features | 802.1X |
| VLAN Support | Up to 4096 VLANs |
| QoS Support | Yes |
| Supervisor Engine Options | Sup8-E |
Describes the features of Catalyst 4500 E-series switches.
Details the available supervisor engines for Catalyst 4500 E-series switches.
Covers the specifications and types of power supplies used.
Details power needs and heat dissipation specifications for the switches.
Provides guidelines for connecting AC power supplies to site power.
Instructions for mounting the switch into a standard equipment rack.
How to remove and install AC and DC input power supplies.
Steps to verify successful system boot and operation.
How to use LEDs to diagnose startup issues.
Steps to isolate and resolve power subsystem problems.
Guide to assigning IP address and basic configuration details.
To Next Page