Cisco Catalyst 4500e Series User Manual

A-6
Catalyst 4500 E-Series Switches Installation Guide
OL-13972-01
Appendix A Specifications
Catalyst 4500 Power Supplies
Catalyst 4500 Power Supplies
Tables A-5 through A-12 list the specifications for the Catalyst 4500 series power supplies, which can
be used in any Catalyst 4500 E-series switch.
Note All Catalyst 4500 series switch AC-input power supplies require single-phase source AC. The source AC
can be out of phase between multiple power supplies or multiple AC-power plugs on the same power
supply because all AC power supply inputs are isolated. Each chassis power supply should have its own
dedicated branch circuit: 15 A or 20 A for North America and circuits sized to local and national codes
for International locations.
For more information about power management and planning, refer to the “Environmental Monitoring
and Power Management” chapter in the Catalyst 4500 Series Switch Cisco IOS Software Configuration
Guide version appropriate for your software.
Redundancy
Supervisor engine yes
Power supply 1 + 1
Table A-4 Catalyst 4510R-E Switch Specifications (continued)
Item Specification

Cisco Catalyst 4500e Series Specifications

General

Series	Catalyst 4500E Series
Stackable	No
Chassis Options	3-slot, 6-slot, 7-slot, 10-slot
Power Supply Options	AC, DC
Redundancy	Power supply redundancy, supervisor engine redundancy (1+1)
Layer Support	Layer 2
Virtualization	Yes (Virtual Switching System - VSS)
Form Factor	Modular
Ports	Gigabit Ethernet, 10 Gigabit Ethernet, 40 Gigabit Ethernet, and 100 Gigabit Ethernet options depending on the line cards
Jumbo Frame Support	Yes
Features	Flexible NetFlow, TrustSec
Maximum Port Density	Up to 384 ports per chassis
Operating System	Cisco IOS XE
Management	CLI, SNMP, Cisco Prime Infrastructure, Cisco DNA Center
Security Features	802.1X
VLAN Support	Up to 4096 VLANs
QoS Support	Yes
Supervisor Engine Options	Sup8-E