EasyManuals Logo

Cisco Catalyst 4500e Series User Manual

Cisco Catalyst 4500e Series
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
CHAPTER
2-1
Catalyst 4500 E-Series Switches Installation Guide
OL-13972-01
2
Preparing for Installation
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Statement 1024
Warning
Class 1 laser product.
Statement 1008
If you will be using your switch as a PoE source, the following warning applies:
Warning
Voltages that present a shock hazard can exist on inline power circuits if interconnections are made
by using uninsulated exposed metal contacts, conductors, or terminals. Avoid using such
interconnection methods unless the exposed metal parts are in a restricted access location and users
and service people who are authorized to access the location are made aware of the hazard. A
restricted access area can be accessed only through the use of a special tool, lock and key, or other
means of security.
Statement 1072
This chapter describes how to prepare your site for the installation of the switch. The information is
presented in these sections:
Electrostatic Discharge, page 2-2
Site Power Requirements and Heat Dissipation, page 2-3
Power Connection Guidelines for AC-Powered Systems, page 2-3
Site-Planning Checklist, page 2-11

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500e Series and is the answer not in the manual?

Cisco Catalyst 4500e Series Specifications

General IconGeneral
SeriesCatalyst 4500E Series
StackableNo
Chassis Options3-slot, 6-slot, 7-slot, 10-slot
Power Supply OptionsAC, DC
RedundancyPower supply redundancy, supervisor engine redundancy (1+1)
Layer SupportLayer 2
VirtualizationYes (Virtual Switching System - VSS)
Form FactorModular
PortsGigabit Ethernet, 10 Gigabit Ethernet, 40 Gigabit Ethernet, and 100 Gigabit Ethernet options depending on the line cards
Jumbo Frame SupportYes
FeaturesFlexible NetFlow, TrustSec
Maximum Port DensityUp to 384 ports per chassis
Operating SystemCisco IOS XE
ManagementCLI, SNMP, Cisco Prime Infrastructure, Cisco DNA Center
Security Features802.1X
VLAN SupportUp to 4096 VLANs
QoS SupportYes
Supervisor Engine OptionsSup8-E

Related product manuals