Cisco Catalyst 4500e Series User Manual

B-1
Catalyst 4500 E-Series Switches Installation Guide
OL-13972-01
APPENDIX
B
Repacking a Switch
If you need to return your Catalyst 4500 E-series switch to the factory, use the instructions in this
appendix to repack your switch in preparation for shipping.
To repack the switch using the original packaging material, follow these steps:
Step 1 Slide the pieces of the packing foam over the Catalyst 4500 E-series switch. (See Figure B-1.)
Step 2 Place the documentation and accessory kit in the box or poly bag provided.
Step 3 Place the box or poly bag containing the documentation and accessory kit on top of the packing material.
Step 4 Place the switch (with packing foam pieces) into the packing carton.
Step 5 Fold in the top flaps of the packing carton and seal with packing tape.

Cisco Catalyst 4500e Series Specifications

General

Series	Catalyst 4500E Series
Stackable	No
Chassis Options	3-slot, 6-slot, 7-slot, 10-slot
Power Supply Options	AC, DC
Redundancy	Power supply redundancy, supervisor engine redundancy (1+1)
Layer Support	Layer 2
Virtualization	Yes (Virtual Switching System - VSS)
Form Factor	Modular
Ports	Gigabit Ethernet, 10 Gigabit Ethernet, 40 Gigabit Ethernet, and 100 Gigabit Ethernet options depending on the line cards
Jumbo Frame Support	Yes
Features	Flexible NetFlow, TrustSec
Maximum Port Density	Up to 384 ports per chassis
Operating System	Cisco IOS XE
Management	CLI, SNMP, Cisco Prime Infrastructure, Cisco DNA Center
Security Features	802.1X
VLAN Support	Up to 4096 VLANs
QoS Support	Yes
Supervisor Engine Options	Sup8-E