Cisco Catalyst 9400 Series User Manual

CHAPTER 11
Related Documentation
For related installation and configuration information, refer to the following:
Release and General Information
Release Notes: https://www.cisco.com/c/en/us/support/switches/catalyst-9400-series-switches/
products-release-notes-list.html
Provides an overview of the hardware and software features introduced in every release, unsupported features,
important restrictions and limitations, and open and resolved caveats with the software.
Hardware Documentation
• Hardware Installation Guide: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9400/hardware/
install/b_c9400_hig.html
Provides a functional overview of the switch, describes how to install and rack-mount the switch, and
make connections to the switch. It describes how to install the power supplies and how to replace the
fan tray assembly. It also includes technical specifications and troubleshooting guidance.
• Supervisor Module Installation Note: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9400/
hardware/sup_install/b-c9400-sup-note.html
Provides an overview of the available supervisor modules, major features, chassis compatibility
information, slot restrictions, and describes how to correctly install and uninstall a supervisor module.
• Switching Module Installation Note: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9400/
hardware/sw_mod_install/b-c9400-mod-note.html
Provides an overview of the supported switching modules or line cards, major features, describes how
to correctly install and uninstall a switching module, and transceiver support.
• Regulatory Compliance & Safety Information Document: https://www.cisco.com/c/dam/en/us/td/docs/
switches/lan/catalyst9400/hardware/regulatory/RCSI-0315-book.pdf
Consolidated list of safety warnings relevant to Catalyst 9400 Series Switches (all chassis models),
supervisor modules, line cards and any other hardware components.
Software Documentation
• Software Configuration Guide: https://www.cisco.com/c/en/us/support/switches/
catalyst-9400-series-switches/products-installation-and-configuration-guides-list.html
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
177

Cisco Catalyst 9400 Series Specifications

General

Series	Catalyst 9400 Series
Form Factor	Rack-mountable
Operating System	Cisco IOS XE
Uplink Options	40G and 100G uplinks
Stacking	Not supported
Layer Support	Layer 2 and Layer 3
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 90% noncondensing
Power Supply Options	AC and DC power supplies
Redundancy	Power supply, supervisor engine
Modular Slots	7 or 10
MAC Address Table Size	256, 000
Security Features	ACLs, TrustSec, MACsec
Management	CLI, SNMP, NETCONF, RESTCONF, Cisco DNA Center