Cisco Catalyst 9400 Series User Manual

Installing the Shelf Kit L Brackets
The switch chassis is shipped with two L brackets installed on the front sides of the chassis. If you are
rack-mounting the switch using the Shelf accessory, these L brackets must be removed and replaced with L
brackets that are part of the shelf kit
Before you begin
You have ordered and received the shelf kit.
Procedure
Step 1 Remove and discard the L brackets and the ten mounting screws that the chassis is shipped with. Do not re-use
them during any part of the installation process.
Figure 10: L Brackets the Chassis is Shipped With
--L Brackets that the chassis is shipped with1
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
54
Installing the Switch
Installing the Shelf Kit L Brackets

Cisco Catalyst 9400 Series Specifications

General

Series	Catalyst 9400 Series
Form Factor	Rack-mountable
Operating System	Cisco IOS XE
Uplink Options	40G and 100G uplinks
Stacking	Not supported
Layer Support	Layer 2 and Layer 3
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 90% noncondensing
Power Supply Options	AC and DC power supplies
Redundancy	Power supply, supervisor engine
Modular Slots	7 or 10
MAC Address Table Size	256, 000
Security Features	ACLs, TrustSec, MACsec
Management	CLI, SNMP, NETCONF, RESTCONF, Cisco DNA Center