Cisco Catalyst 9400 Series User Manual

preparing for installation (continued)
dust 30
Electromagnetic interference 31
particles 30
power source interruptions 32
radio frequency interference 31
safety 34
shock 32
system grounding 33
temperature 28
vibration 32
preventing ESD damage 35
R
removing and replacing 85, 96, 98, 110
fan tray 85
power supply module 96, 98, 110
AC input 98
DC input 110
S
service mode 86
Site Requirements 27
standard accessory kit 45
start-up configuration 139
starting the terminal-emulation software 168
supervisor module 157
power requirements and heat dissapation 157
T
technical specifications 143, 145, 147, 148, 152, 156, 157, 158
2100-W AC-Input Power Supply Module 148
3200-W AC-Input Power Supply Module 152
3200-W DC-Input Power Supply Module 156
C9404R 143
C9407R 145
C9410R 147
power and heat values 157
weights 158
troubleshooting 129, 130, 131, 132, 133, 135, 137, 142
about 129
AC-input power supply module 132
Cisco TAC 142
DC-input power supply module 133
fan tray 135
fan tray CLI commands 137
power supply CLI commands 132
system boot verification 129
system messages 131
using LEDs to identify problems 130
with software 131
W
weight 158
chassis 158
line cards 158
power supply module 158
supervisor module 158
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
IN-3
INDEX

Cisco Catalyst 9400 Series Specifications

General

Series	Catalyst 9400 Series
Form Factor	Rack-mountable
Operating System	Cisco IOS XE
Uplink Options	40G and 100G uplinks
Stacking	Not supported
Layer Support	Layer 2 and Layer 3
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 90% noncondensing
Power Supply Options	AC and DC power supplies
Redundancy	Power supply, supervisor engine
Modular Slots	7 or 10
MAC Address Table Size	256, 000
Security Features	ACLs, TrustSec, MACsec
Management	CLI, SNMP, NETCONF, RESTCONF, Cisco DNA Center