Cisco Catalyst 9400 Series User Manual

Configuring the Switch Using the CLI 168
Starting the Terminal-Emulation Software 168
Connecting to a Power Source 168
Connecting the RJ-45 Console Port 169
Connecting the USB Console Port 169
IP Settings 170
Performing the Initial Configuration 170
Configuring the Switch in the ROMMON Mode 173
Installing and Uninstalling the USB Driver 174
Installing the Cisco Microsoft Windows USB Device Driver 174
Installing the Cisco Microsoft Windows 7 USB Driver 174
Uninstalling the Cisco Microsoft Windows USB Driver 174
Uninstalling the Cisco Microsoft Windows 7 USB Driver 174
Related Documentation 177
CHAPTER 11
Analysis of Cabling Requirements for IEEE 802.3bt Type 4 Devices 179
APPENDIX A
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
vi
Contents

Cisco Catalyst 9400 Series Specifications

General

Series	Catalyst 9400 Series
Form Factor	Rack-mountable
Operating System	Cisco IOS XE
Uplink Options	40G and 100G uplinks
Stacking	Not supported
Layer Support	Layer 2 and Layer 3
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 90% noncondensing
Power Supply Options	AC and DC power supplies
Redundancy	Power supply, supervisor engine
Modular Slots	7 or 10
MAC Address Table Size	256, 000
Security Features	ACLs, TrustSec, MACsec
Management	CLI, SNMP, NETCONF, RESTCONF, Cisco DNA Center