Cisco Catalyst 9400 Series User Manual

--Handholds closest to the rack posts, pushed
in.
1
Step 5 Continue sliding the chassis in until the second pair of handholds are near the rack posts
Figure 17: Sliding the Chassis in - Part 2
--Chassis is slid in until the second pair of
handholds are near the rack posts.
1
Step 6 Push in the the second pair of handholds and continue sliding the chassis in until the L brackets make contact
with the rack posts.
Step 7 Secure the chassis to the rack with either the 10-32 or 12-24 pan head screws from the chassis standard
accessory kit.
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
62
Installing the Switch
Rack-Mounting the Chassis

Cisco Catalyst 9400 Series Specifications

General

Series	Catalyst 9400 Series
Form Factor	Rack-mountable
Operating System	Cisco IOS XE
Uplink Options	40G and 100G uplinks
Stacking	Not supported
Layer Support	Layer 2 and Layer 3
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 90% noncondensing
Power Supply Options	AC and DC power supplies
Redundancy	Power supply, supervisor engine
Modular Slots	7 or 10
MAC Address Table Size	256, 000
Security Features	ACLs, TrustSec, MACsec
Management	CLI, SNMP, NETCONF, RESTCONF, Cisco DNA Center