Cisco Catalyst 9500

DescriptionAttribute
NondisruptiveDisruptive or Nondisruptive
Do not disable. Run this as an on-demand test and a
health-monitoring test.
Recommendation
On.Default
Cisco IOS XE Fuji 16.8.1.Intitial release
Displays a syslog message if the test fails.Corrective action
All modules.Hardware support
TestScratchRegister
This Scratch Register test monitors the health of ASICs by writing values into registers and reading back the
values from these registers. This test runs every 90 seconds.
DescriptionAttribute
Nondisruptive.Disruptive or Nondisruptive
Do not disable. This can be run as a health-monitoring
test and also as an on-demand test.
Recommendation
On.Default
Cisco IOS XE Fuji 16.8.1.Intitial release
Displays a syslog message if the test fails.Corrective action
All modules.Hardware support
TestConsistencyCheck
This test checks if the hardware programming is correct. This test checks with the forwarding object manager
to identify incomplete entries or long-pending configurations to the hardware. This test runs every 90 seconds.
DescriptionAttribute
Nondisruptive.Disruptive or Nondisruptive
Do not disable. This can be run as a health-monitoring
test and also as an on-demand test.
Recommendation
On.Default
Cisco IOS XE Amsterdam 17.2.1.Intitial release
Displays a syslog message if the test fails.Corrective action
All modules.Hardware support
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
198
Configuring Online Diagnostics
Generic Online Diagnostics (GOLD) Tests