EasyManuals Logo

Cisco Catalyst IE9300 User Manual

Cisco Catalyst IE9300
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
CHAPTER 5
Switch Configuration with the CLI Setup Program
Configuring the Switch with the CLI-Based Setup Program, on page 55
Accessing the CLI Through the Console Port, on page 55
Entering the Initial Configuration Information, on page 57
Configuring the Switch with the CLI-Based Setup Program
This chapter provides a command-line interface (CLI)-based setup procedure for the switch.
Before connecting the switch to a power source, review the safety warnings in Warnings, on page 13 section
of the Switch Installation chapter.
Accessing the CLI Through the Console Port
You can enter Cisco IOS commands and parameters through the CLI. Use one of these options to access the
CLI:
RJ-45 Console Port
Complete the steps in this section to access the CLI through the RJ-45 console port.
Step 1 Connect one end of the console cable to your PC.
Doing so may require an adapter for USB to RJ45 or DB-9 to RJ-45.
Step 2 Connect the other end of the cable or adapter to the switch console port.
Step 3 Start the terminal-emulation program on the PC or the terminal.
The program, frequently a PC application such as HyperTerminal or ProcommPlus, makes communication between the
switch and your PC or terminal possible.
Step 4 Configure the baud rate and character format of the PC or terminal to match the console port characteristics:
9600 baud
8 data bits
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
55

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst IE9300 and is the answer not in the manual?

Cisco Catalyst IE9300 Specifications

General IconGeneral
BrandCisco
ModelCatalyst IE9300
CategorySwitch
LanguageEnglish

Related product manuals