Cisco Catalyst IE9300 User Manual

Attach Brackets for 23-Inch Racks
Follow the instructions in this section to attach 23-inch brackets (RM-RGD-23IN=).
23-inch and ETSI brackets should not be used in high vibration environments, including any railway
application (EN50155).
Note
For IP-30 compliance, insert rubber plugs in the same holes as described in the section Attach Brackets
for 19-Inch Racks for IP-30 Compliance (Optional), on page 18. Do so before installing the brackets.
Note
Before you begin
Complete the tasks in the section Preparing for Installation.
Attach the brackets to the switch, as shown in one of the illustrations.
Figure 10: Attaching Brackets for 23-inch Racks (Front Mounting)
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
20
Switch Installation
Attach Brackets for 23-Inch Racks

Cisco Catalyst IE9300 Specifications

General

Brand	Cisco
Model	Catalyst IE9300
Category	Switch
Language	English