EMC Environmental Conditions for Products Installed in the
European Union
This section applies to products to be installed in the European Union.
The equipment is intended to operate under the following environmental conditions with respect to EMC:
• A separate defined location under the user’s control.
• Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.
• AC-power distribution shall be one of the following types, where applicable: TN-S and TN-C as defined
in IEC 364-3.
In addition, if equipment is operated in a domestic environment, interference could occur.
Hazardous Locations Standards
The following table lists the standards that are used for hazardous locations approval and certification in
English and French.
Table 18: Standards for Hazardous Locations
Les normes suivantes ont été appliquées pour les
approbations et les certifications dans le cadre
d'environnements dangereux:
The following standards were used for the
hazardous locations approvals and certifications:
UL 121201, Éd. 9UL 121201, Ed. 9
CAN/CSA C22.2 No. 60079-0:19, 4e éd., fevrier 2019CAN/CSA C22.2 No. 60079-0:19, 4th Edition,
February 2019
AN/CSA C22.2 No. 60079-7:16CAN/CSA C22.2 No. 60079-7:16
A C22.2 No. 213-Éd. 3CSA C22.2 No. 213-Ed. 3
EN IEC 60079-0:2018EN IEC 60079-0:2018
EN 60079-7: 2015+A1:2018EN 60079-7: 2015+A1:2018
UL 60079-0, 7e éd., 2019-03-26UL 60079-0 7th Edition, 2019-03-26
UL 60079-7, 5e éd., 2017-02-24UL 60079-7, 5th Edition, 2017-02-24
UL 60079-15, 5e éd., 2020-04-07UL 60079-15 5th Edition, 2020-04-07
CAN/CSA-C22.2 No 60079-15:18, novembre 2018CAN/CSA-C22.2 No 60079-15:18, November 2018
EN IEC 60079-15: 2019EN IEC 60079-15: 2019
The following table lists the hazardous location strings in English and French.
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
76
Hazardous Location Installation Information
EMC Environmental Conditions for Products Installed in the European Union
To Next Page
Loading...
Need help?
General