Cisco Catalyst IW6300 Series User Manual

https://www.cisco.com/c/en/us/products/collateral/wireless/industrial-wireless-6300-series/datasheet-c78-742907.html
Hardware Models
Figure 1: IW-6300H Access Points
The model numbers (or part numbers) and configuration for the Cisco Catalyst IW6300 Heavy Duty Series
Access Points are described in the following table.
Table 1: Cisco Industrial Wireless 6300 Series Access Point Model Numbers and Descriptions
ConfigurationModel (or part number)
IP66 and IP67 rated, hazardous location certified, AC power version.
This model has 4 external antenna ports and contains a 2.4 GHz and 5 GHz radio with an
option to configure in centralized, Flexconnect, or mesh mode and supports AC power
source.
IW-6300H-AC-x-K9
IP66 and IP67 rated, hazardous location certified, DC wide range power version.
This model has 4 external antenna ports and contains a 2.4 GHz and 5 GHz radio with an
option to configure in centralized, Flexconnect, or mesh mode, and supports 10.8 VDC to
36 VDC power source.
The marked DC input range is an absolute range. Do not apply tolerances.
Note
IW-6300H-DC-x–K9
Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide
3
Overview
Hardware Models

Cisco Catalyst IW6300 Series Specifications

General

Model	Cisco Catalyst IW6300 Series
Category	Wireless Access Point
MU-MIMO	Yes
Ingress Protection	IP67
Power Options	PoE, DC power
Frequency Bands	2.4 GHz and 5 GHz
MIMO	4x4
Input Power	48V DC
Power over Ethernet	802.3at
Mounting	Wall, Pole, Ceiling
Security	WPA3
Management	Cisco DNA Center