Cisco Catalyst IW6300 Series User Manual

Removing the Access Point from Service
When removing an access point from service, make sure you remove power from the access point before
opening the cover and disconnecting the input wiring. When removing the wiring, the ground connection
should be the last to be disconnected.
Conducting Periodic Inspections
The access point should be inspected periodically to ensure normal and airtight operation in the hazardous
location environment. Table 6: Periodic Inspection Table, on page 47 lists the inspection routines and their
periodicity.
Table 6: Periodic Inspection Table
PeriodicityInspection Routine
Every 3
years
Inspect O-ring seals and exterior electrical connections for aging, corrosion, and low ground
resistance.
Every 5
years
Inspect cover and liquid-tight adapter gaskets for airtightness.
Conducting Periodic Cleaning
The access point is designed to not require periodic cleaning.
Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide
47
Installing the Access Point
Removing the Access Point from Service

Cisco Catalyst IW6300 Series Specifications

General

Model	Cisco Catalyst IW6300 Series
Category	Wireless Access Point
MU-MIMO	Yes
Ingress Protection	IP67
Power Options	PoE, DC power
Frequency Bands	2.4 GHz and 5 GHz
MIMO	4x4
Input Power	48V DC
Power over Ethernet	802.3at
Mounting	Wall, Pole, Ceiling
Security	WPA3
Management	Cisco DNA Center