Cisco Catalyst IW6300 Series User Manual

MeaningColorLED Message
Type
A software upgrade is in progress
Blinking AmberOperating
Status
Discovery/join process is in progressCycling through Green, Red,
and Amber
This status indicates that the Access Point location command
has been invoked.
Rapidly cycling through Red,
Green, Amber, and Off
This status indicates that an Ethernet link is not operationalBlinking Red
Configuration recovery is in progress (the Reset button has
been pushed for 2-3 seconds)
Blinking AmberBoot loader
warnings
There is an Ethernet failure or an image recovery (the Reset
button has been pushed for 20-30 seconds)
Red
An image recovery is in progress (the Reset button has been
released)
Blinking Green
There has been a DRAM memory test failure
RedBoot loader
errors
There has been a FLASH file system failureBlinking Red and Amber
This sequence may indicate any of the following:
• Environment variable failure
• Bad MAC address
• Ethernet failure during image recovery
• Boot environment failure
• No Cisco image file
• Boot failure
Blinking Red and Off
There has been a software failure; a disconnect then reconnect
of the unit power may resolve the issue
RedAP OS errors
This is a general warning of insufficient inline powerCycling through Red, Green,
Amber, and Off
The access point port LED signals are listed in the following table.
Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide
53
Troubleshooting
Monitoring the Access Point LEDs

Cisco Catalyst IW6300 Series Specifications

General

Model	Cisco Catalyst IW6300 Series
Category	Wireless Access Point
MU-MIMO	Yes
Ingress Protection	IP67
Power Options	PoE, DC power
Frequency Bands	2.4 GHz and 5 GHz
MIMO	4x4
Input Power	48V DC
Power over Ethernet	802.3at
Mounting	Wall, Pole, Ceiling
Security	WPA3
Management	Cisco DNA Center