Cisco Catalyst IW6300 Series

To Next Page

To Previous Page

Procedure

Step 1 Log into your controller using a web browser.

Step 2 Click Wireless. When access points associates to the controller, the access point name appears in the AP Name

list.

Step 3 Click on an access point name.

Step 4 Find the Mesh Information section, and enter the new BGN in the Bridge Group Name field.

Step 5 Click Apply.

Step 6 Repeat Steps 2 through 5 for each access point.

Step 7 Log out from your controller, and close your web browser.

Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide

Troubleshooting

Changing the Bridge Group Name

Cisco Catalyst IW6300 Series - Page 63