•
Additional References, page 35
•
Feature Information for Advanced-Mode DSG 1.2 for the Cisco CMTS Routers, page 35
Hardware Compatibility Matrix for Cisco cBR Series Routers
The hardware components introduced in a given Cisco IOS-XE Release are supported in all subsequent
releases unless otherwise specified.
Note
Table 3: Hardware Compatibility Matrix for the Cisco cBR Series Routers
Interface CardsProcessor EngineCisco CMTS Platform
Cisco IOS-XE Release 3.15.0S
and Later Releases
Cisco cBR-8 CCAP Line Cards:
• PID—CBR-LC-8D30-16U30
• PID—CBR-RF-PIC
• PID—CBR-RF-PROT-PIC
Cisco IOS-XE Release 3.15.0S
and Later Releases
Cisco cBR-8 Supervisor:
• PID—CBR-CCAP-SUP-160G
• PID—CBR-SUP-8X10G-PIC
Cisco cBR-8 Converged
Broadband Router
Prerequisites for Advanced-Mode DSG Issue 1.2
No special equipment or software is needed to use the Advanced-Mode DSG Issue 1.2 feature.
Restrictions for Advanced-Mode DSG Issue 1.2
This section contains restrictions that are specific to A-DSG 1.2 on a Cisco CMTS router.
DSG Configuration File Transfer Operations
DSG 1.2 does not support the copying of a DSG configuration file from a TFTP server, file system, or bootflash
to the running configuration.
Multicast Configuration Restrictions
IP multicasting must be configured for correct operation of A-DSG 1.2. Specifically, IP multicast routing
must be set in global configuration. Also, IP PIM must be configured on all bundle interfaces of cable interfaces
that are to carry multicast traffic.
Cisco cBR Series Converged Broadband Routers Application—Voice and Video Configuration Guide
10
Advanced-Mode DOCSIS Set-Top Gateway 1.2 for the Cisco CMTS Routers
Hardware Compatibility Matrix for Cisco cBR Series Routers
To Next Page
Loading...
Need help?
General
